The Zamp Racing Z-20 Anti-Fog Series Shield is made with anti-fog coating on the inside of the shield. This Z-20 anti-fog shield helps prevent fogging during moist or humid conditions (or cold weather) and is also perfect for a variety of helmet applications.

The Z-20 fits a variety of Zamp helmets, including:

RZ-42 (youth and adult), RZ-37 Y, RZ-70 (switch), RL-70, RZ-64, RZ-62, RZ-62 Air, RZ-60, RZ-60V, RZ-36, RZ-36 DIRT, RZ-36 Air, RZ-56, RZ-59, RZ-65D.

Z-20 Shield Replacement:

NOTE: DO NOT USE power tools or overtighten screws when changing shields.
Step 1 - Lay a towel on a flat surface and set the helmet on it.
Step 2 - Remove the shield pivot tensioners on each side. (This is the smaller screw on the sides of the shield.)
Step 3 - Remove the shield pivot screws on each side. (This is the larger screw on the sides of the shield. For best results, we suggest using a quarter to loosen/tighten these screws.)
Step 4 - Remove the shield. We suggest using a soft cloth towel to wipe down the rubber seal as well as where the shield mounts to the helmet for best results.
Step 5 - Place the new shield on the helmet. There are two white washers that go between the shield and helmet, make sure these are in place before re-installing the shield pivot screws.
Step 6 - Hand thread the shield pivot screws to hold the shield in place. Once hand threaded, use a quarter to tighten until snug with the helmet shell. Do not overtighten.
Step 7 - Hand thread the shield pivot tensioners, then tighten to desired tension for shield movement.

Szűrés:

Rendezési szempont:

25 termék

Szűrés és rendezés

25 termék

Helmets