Can-Am / Polaris MPI Steering Wheel + Quick Release Setup

The MPI (Max Papis Innovations) Steering Wheel and Quick Release Setup for the Can Am/ Polaris SXS allows you to convert your steering wheel into a race-ready quick release hub and steering wheel.

The MPI GT Model is a multifunctional steering wheel. Safety is always in the forefront of all MPI products. The inner structure has been engineered to deform under elevated impacts, absorbing the load and reducing the effect on the drivers upper body, offering an engineered safety advantage. The inner foam injection has been developed to have the highest vibration absorption rate in the industry. The special oval shaped grip makes holding the wheel a natural feel for the driver. The new aluminum D shaped structure features a unibody with no horn button for increase rigidity and durability and a flat bottom for extra leg room and easy exit adding a sporty look to the unit. The suede covering and its parallel MPI Orange™ hand stitched finish, give a very high grip feel, reducing the effort needed to hold the wheel while increasing driver feeling and giving a sporty look. It is a preferred material for track and tuning use. 

The MPI Steering Wheel Quick-Release 6 Bolt Adapter Hub is made of lightweight hard coated aerospace 6061-T6 aluminum featuring PLDP (Push Lock Double Pins) Technology. The double safety pin and hard-coated aluminum spacer design will assure that the steering wheel is attached securely. This quick-release setup was engineered to have ZERO play. It is hard-coated a Ergonomic-designed release collar.

All necessary hardware for proper installation is included.

Features/Specs:

D-Shaped Suede Steering SXS Aluminum Steering Wheel
• MPI Safety™ construction
• D-shaped flat bottom for easy entry & exit
• Minimal dish / extreme ergonomic oval grip
• NEW redesigned one-piece integral aluminum structure
• Suede covered with parallel orange stitching + MPI Orange™ marker
• Made in Italy

Measurements:

• Diameter – 13 inches / 330mm
• Weight – 2 lbs / 900g
• Dish Depth – 1.25 inches / 32mm
• Hole Pattern – 6 x 70mm / 6 x 2 ¾”

MPI Steering Wheel Quick-Release 6 Bolt Adapter Hub

• SFI Tested and approved; SFI 42.1
• “PLDP” Technology: Push Lock Double Pins
• Hard coated aerospace 6061-T6 aluminum construction
• This quick-release setup was engineered to have ZERO play. It is hard-coated a
  Ergonomic-designed release collar
• CNC machined slots for maximum weight reduction
• Coil collar retainer
• Fully disassemble for maintenance
• Compatible with Polaris, Can-Am, and E-Z-GO

Spline Specs Only:

• 19 tooth design
• Length: 2 7/8″
• Outside Diameter: 1″
• Inside Diameter: 1″